HD Steel Straight Sections

Steel Straight Sections Numbering Example:
09 - 1952 - 0020 - 36 -
Bottom Type
06 - 6" Rung Spacing
09 - 9" Rung Spacing*
12 - 12" Rung Spacing
18 - 18" Rung Spacing
VT - Ventilated/Trough
SF - Solid Flat Bottom
* Standard Rung Spacing 		Tray System Number
This identifies the specific tray design and is used as a product number prefix for straight sections. 		Length
0010 - 10'-0"
0012* - 12'-0"
0020† - 20'-0"
0024 - 24'-0"
* Standard for Series 1
†w Standard for Series 2 		Width
06 - 6"
09 - 9"
12 - 12"
18 - 18"
24 - 24"
30 - 30"
36 - 36" 		Rung Options
Add suffix for non-standard rung.

M

Steel,
Mill galvanized

G

Steel,
Hot-dip galvanized

Click on product number to download data sheet.

Rail Height Load Depth Rail Flange Nema Class CSA Class Ladder type only Ladder Ventilated / Trough Solid Bottom Amp Rating Safe Load Data (LBS./FT.)
Support Span (FT.) / Deflection (IN.)
20 22 24 26 28 30 32 34 36 38 40 45 50
8" 6" 2 1/4" 20C+ - 1952 1962 1972 600 203 0.88 167 1.06 141 1.27 120 1.49 103 1.72 90 1.98 81 2.22 68 2.47 60 2.72 54 3.06 48 3.31        
4" 1953 1963 1973 600 360 0.98 298 1.18 250 1.41 213 1.65 184 1.92 160 2.20 139 2.47 121 2.74 107 3.05 95 3.35 85 3.69 66 4.00 51 5.37
10" 5" 4" 1954 contact Cablofil/Legrand contact Cablofil/Legrand 600 900 1.04 744 1.26 625 1.50 533 1.77 459 2.05 400 2.35 347 2.64 304 2.95 268 3.26 238 3.60 212 3.94 164 4.87 124 5.62

Connectors & Fittings:

Necessary connectors and fasteners are supplied with all trays and fittings. Extra connectors for field cuts or spares must be ordered separately.

Safe Load:

Allowable cable load in pounds per linear foot uniformly distributed. Based on tray with standard rung on 9" centers and supported on simple beam with safety factor of 1.5 per NEMA VE1.

Concentrated Load:

All ladders with solid rungs and trays with corrugated bottoms will support a 200 lb. concentrated load applied at the center of the tray in addition to the NEMA -rated cable load without collapse (except NEMA Class 12A trays).

*Rail flange size determines which series connectors are needed. Please consult the chart above to determine the connectors you need.

SERIES 1

Fitting side rails have 2" tangents (flat portion beyond curvature) at the end of each fitting, to accommodate splice plates with four holes.

SERIES 2

Fitting side rails have 5" tangents at the end of each fitting, to accommodate splice plates with eight holes.